![]() ![]() The other common mistake is not issuing the ATWR command to save your changes, then losing your configuration when the radio is powered down. This can happen quite frequently when you’re starting out, but you’ll get better at it as you go along. If you don’t get an OK response, most likely you took more than ten seconds to issue the command and you’ve dropped out of command mode. Note: You should get an OK response after issuing each command to set parameters, and another OK response when you write the changes to firmware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |